Recess turning

Special toolholder
Special toolholder
Recess turning

The machining of a recess, which was largest compared with the entry hole, was made possible with this special tool developed especially for this purpose.

In this case the special solution was the only way to get the target (recess turning).

Therefore it is important to maintain a frank and open dialogue with the customer and direct it towards special solutions only if they are really necessary. As it should be in the opposite case, when no standard tool is able to perform the required machining, the way to choose a special tool is the only possible one.

Only in this way the results achieved will be most appreciated, because they were born from the collaboration of all involved.

Since more over 30 years C.R.M. di Mazzoccato Arturo & Figli s.r.l. from its only site in Fino Mornasco offers special tools, to better meet the needs of customers operating in chip removal machining in sectors where competitiveness is fundamental.

The effect of these special tools on production costs is shown in this visual scheme, or choose to experience it yourself, by filling out the Contact form to request more information or an offer, which will illustrate how can fit your requirements the “C.R.M. Mazzoccato s.r.l.’s” Tooling System.

“DIFFERENT: to make the difference”.

Have Questions?

We will answer as soon as possible